HOT-SWAP INVERTERS
SYSTEMS TO 18kVA

The Gravitas Energy Systems SABRE is an integrated inverter power system, including, inverter, static transfer switch, controller, and remote communications interface modules.

The modular design and N+1 redundant capability of SABRE allows the system to be configured for a variety of complex Telecommunication and Industrial power requirements.

An “All Master” dynamic mechanism prevents interruption to critical loads from one or more inverter module failures.

SABRE’s static transfer switch provides automatic instantaneous load transfer, ensuring secure uninterrupted operation of sensitive electronic equipment.

The microprocessor controller gives real-time system status via an LCD display and LEDs indicators and also allows settings to be programmed through the front panel. With the communication interface module installed, it is possible to control and monitor the system remotely.

Users who would prefer to buy a fully integrated pre-configured / pre-assembled system can choose one of the standard packages listed below with 3kVA or 6kVA capacity.

These systems include the Static Transfer Switch, Controller and Communications Module complete with SNMP Alarm Trap facility as standard and provide either a single bulk AC output or distributed AC output with or without Manual Bypass Switch.

SAFETY STANDARDS

• UL60950-1
• CSA22.2, No. 60950-1
• EN60950-1

TWO-YEAR WARRANTY

For SABRE system brochure, click here

For pre-configured systems data sheet, click here

For General Installation and Operating Manual, click here

For software downloads and associated manuals, click here

FEATURES

• Hot-Swap Replacement in Shelves
• 19- or 23-Inch Rack Mounting
• 120 or 230VAC Output
• 50 or 60Hz Low Distortion Sine Wave
• 40.5 to 58 VDC Input
• 1000 or 1500 VA Module Output
• Scalable to 18kVA
• 10.5 VA per Cubic Inch Density
• Fully Isolated from Battery Input
• 90% Typical Efficiency
• DSP Management & Control
• Smart Fan Speed Control
• Powers Reactive Loads
• Parallel Capable
• N+1 Redundant Operation
• LED Status Indicators

APPLICATIONS

• Wireless Base Stations
• Central Office Power
• AC Appliances
• Utility Substations
• Battery Backup Systems
• Data Center Power
• Other Telecom Equipment

Notes:

1. If in doubt about load PF (Power Factor) assume it is 1.0PF.

2. The frequency shown in brackets can be obtained by reprogramming the unit from the system controller.

MOUNTING OPTIONS (19" only)

Add -F to Model Number for Front-Mount or -M for Mid-Mount

Notes:

1. Inverter modules must be ordered separately based on output voltage and total system capacity required.  Module types may not be mixed in the same system.

2. 120VAC inverters are pre-programmed to 60Hz, 230VAC inverters are pre-programmed to 50Hz.  These settings can be changed from the front panel of the controller or remotely using the WINpower client application.

NOTE: To print out the data sheet, you may print from your browser or see a detailed .pdf spec sheet from within Adobe Acrobat. If you need Adobe Acrobat Click Here to download the plug-in.